Why did my pressure washer shut off?

A clogged carburetor is most often the culprit if your pressure washer shuts off after a few minutes (source). As such, checking the carburetor should be the first thing you do.

How do I reset my pressure washer?

Each time the power cord is plugged in to an outlet, the Reset button on the GFCI module must be pressed down to connect to electricity. Check to see if the Reset button has been pressed. Next, confirm the small plastic window below the Reset button shows RED in the window.

Why does my Nilfisk pressure washer keep cutting out?

Pump sucking Valves dirty, worn out or stuck Pump seals worn out Check that hoses and connections are airtight. Clean and replace or refer to local Nilfisk distributor. Machine stops Fuse has blown Incorrect mains voltage Thermal sensor activated Nozzle partially blocked Replace fuse. Switch off other machines.

Why does my greenworks pressure washer keeps shutting off?

Why Does My Greenworks Pressure Washer Keep Shutting Off? A Greenworks pressure washer keeps shutting off due to a problem with the unloader valve. A faulty unloader valve doesn’t divert the water to the inlet, which increases pressure inside the pump, and the washer shuts off.

How do you fix a pressure washer that won’t start?

When the pressure washer runs out of gas, then, the fuel pump overheats and needs to be replaced. You can try to get the pressure washer started again by removing the spark plug, putting about a tablespoon of gasoline or lighter fluid in the socket, replacing and reattaching the spark plug, and trying to start it.

Why does my electric pressure washer keep stopping?

The stalling of the engine of your electric pressure washer may be because of the bad unloader valve, which is due to the pressure inside the pump becoming greater than your engine’s power to rotate your pump.

Is there a fuse in an electric pressure washer?

Check the Fuse: If you have done all the repairs and replacements and your electric pressure washer is still not working, it may have something to do with the fuse. Inspect the fuse if it is blown or not. Replace the blown fuse with a new one and test the device again.

Do power washers have a reset button?

When the trigger is released, water flow stops which the TSS sensed and immediately shuts the unit off. So to review, if the Reset button has been pressed and is holding and the power switch is ON, the power washer is supposed to start up for a second or two and immediately shut off.

Similar Posts